GE Hydran 201i, Instruction Manual, Page: 95 / 300

Main and Extended Menus
Part 17997 Rev. 6, March 2011 4-23
Note: In the versions 2.1 and prior of the H201Ti embedded software, in the Call OnAlarm
mode, the telephone number set in the modem’s register 0 is dialed automatically at
midnight. This function does not exist in version 2.2.
4.5.6.5 H201Ti ID and PowerStat. ID
The H201Ti ID parameter is used to set the Hydran 201T i ’s identification number. An
exclusive identification number must be assigned to each H201T i in a local network.
The PowerStat. ID parameter is used to set the power station’s identification number. The
same power station identification number must be assigned to all H201T i ’s in a local
network, but each local network must have a different power station identification number .
The default values of the H201Ti ID and PowerStat. ID parameters are therefore usually
modified. Furthermore, the H201T i and power station’s identification numbers must
correspond to those assigned to the same H201T i ’s and power station in the Hydran Host
software.
Note: The identification number of each H201Ti must be recorded during the configuration
of the local network.
4.5.7 Relays/Analog Submenu (Extended Menu Only)
The Relays/Analog submenu is used to:
• Read the state of the alarm relays: On or Off .
• Set the operation mode of the three alarm relays.
• Select the triggering conditions of the fail alarm (
FaultTrig. ).
• Read the state of the analog output and TDM signal (in %).
• Set the operation mode of the analog output and TDM signal.
4.5.7.1 Gas H Relay
• RelayH State : Displays the status of the High alarm relay. The two possible states are
explained in Section 10.2.2 on page 10-4.
CAUTION
WARNING
The identification number of at least one H201Ti in a local network
must be set between 1 and 5 (inclusively).