20
Before you call for service…
Troubleshooting Tips
Save time and money! Review the chart on this
page first and you may not need to call for service.
Problem
Possible Causes
What To Do
No soft water
Faucet or fixture where sample was
•
To conserve salt, the installer may have isolated some
taken not plumbed to soft water.
fixtures (outside faucets, toilets, etc.) from soft water.
NOTE:
Be sure sample is from a faucet
From the outlet of the water softening system, trace the
that does not mix soft and hard water.
water flow path, in house plumbing. If soft water is not
For example, a single lever kitchen faucet,
directed to a faucet or fixture where wanted, consult
if the cold side is plumbed to hard water
a plumber.
No salt in the brine tank or
•
Check for a salt bridge or, if the tank is empty, refill with
salt bridged
recommended salt. Press (for 3 seconds) the
TOUCH or
HOLD
button to start an immediate regeneration and restore
soft water supply.
Transformer unplugged at wall outlet or
•
Check for a loss of electrical power to the water
power cable to softener not connected.
softening system, due to any of these conditions and
Fuse blown or circuit breaker popped
correct as needed. With the power supply restored,
on circuit to electrical outlet.
observe the faceplate time display and read
Program
Electrical outlet on a circuit that can
Memory
section.
NOTE:
The electrical outlet for the softener
be switched off.
should be continuously live
so it cannot be accidentally
switched off.
Manual bypass valve in bypass position
•
Be sure the bypass valve stem is positioned properly, with the
knob in the OUT position. Observe instructions on the decal
at the end of the stem.
Valve drain hose pinched, plugged,
•
Any restriction in this drain hose may prevent proper
elevated too high or otherwise
operation of the nozzle and venturi and reduce or
restricted
prevent brine draw during regenerations.
Nozzle and venturi dirty, incorrectly
•
Refer to
Cleaning the Nozzle and Venturi Assembly
instructions.
assembled or damaged
With water pressure to the water softening system off,
take the nozzle assembly apart. Inspect, clean and
replace as needed. Any foreign particle(s), scratches,
nicks, etc., in the passages can prevent operation. Be sure
holes in the gasket are centered over holes in the housing.
NO SOFT WATER – Most Common Problems
:
Check the following before calling for service
•
Salt in softener...at least 1/3 full.
•
By pass valve in “Service” position. Knob should be in the OUT position.
•
Check hardness setting in control. Verify hardness of supply water.
Water hardness can vary throughout the year.
•
Salt Bridge, water not in contact with salt (see Breaking a Salt Bridge section).
Summary of Contents for GXSF23Z
Page 23: ...23 Notes ...
Page 24: ...24 Notes ...
Page 27: ...27 Parts list ...
Page 28: ...28 Parts list 153 ...
