49-1000352 Rev. 2
9
In the Event of a Power Failure
If the power fails, open the door as infrequently as
possible to maintain the temperature. A gradual rise in
temperature should not have any adverse effect on the
wine.
If it is extremely hot, you may want to unload the wine
from the beverage center/wine chiller and move the wine
to a cooler location until power is restored.
The controls may maintain your temperature settings
when the power has been restored. If your settings
are not correct, reset according to the Control Settings
section.
Preparing to Move
8QORDGWKHZLQHWKHQVHFXUHWKHUDFNVE\WDSLQJWKHP
in place to prevent damage.
Be sure the beverage center/wine chiller stays in an
upright position during the move.
CARE
AND CLEANING
Care and Cleaning
Replacing the Bulb
WARNING
Before replacing a burned-out light
bulb, the refrigerator should be unplugged in order to
avoid contact with a live wire filament. (A burned-out
light bulb may break when being replaced.)
7XUQLQJWKHFRQWUROWRWKH2))SRVLWLRQGRHVQRWUHPRYH
power to the light circuit.
8QSOXJWKHZLQHFHQWHUEHYHUDJHDQGZLQHFHQWHU
2. Remove any beverages and shelves as needed for
access.
3. The light bulb is located behind a light shield in the
ceiling of the wine center/beverage and wine center
near the back. To remove the light shield, remove the
screw on the right side of the light shield.
4. Pull down on the back of the light shield to release
the two front tabs.
8QVFUHZWKHOLJKWEXOEIURPWKHVRFNHW
6. Replace with a 15 watt, 120 volt bulb. This type of
bulb is available at most hardware and automotive
parts stores.
WARNING
8VLQJDEXOEUDWHGKLJKHUWKDQZDWWV
may damage the electronic controls on the wine center/
beverage and wine center.
5HLQVWDOOWKHOLJKWVKLHOG
8. Replace the top shelf and beverages.
9. Plug in the wine center/beverage and wine center
Light Shield
Screw
