For models GTD60, GTD65 and GTD68 only, use the
dimension below.
Fixing hole
A
9-1/2” (24.13cm)
Fixing hole
A
10-1/2” (26.67cm)
Cut the duct as shown and keep portion A.
15
Installation Instructions
SIDE OR BOTTOM VENTING
Dryer Exhaust to right of cabinet for Electric
models only.
Dryer Exhaust to left of cabinet for Gas and
Electric models.
Dryer Exhaust to the bottom of cabinet for
Gas and Electric models.
Detach and remove the right (electric models only),
OHIWRUERWWRPNQRFNRXWDVGHVLUHG5HPRYHWKH
screw inside the dryer exhaust duct and save. Pull
the duct out of the dryer.
ADDING A NEW DUCT
5HFRQQHFWWKHFXWSRUWLRQ$RIWKHGXFWWRWKH
blower housing. Make sure that the shortened
duct is aligned with the tab in the base. Use the
screw saved previously to secure the duct in place
through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR EXHAUST TO
SIDE OF CABINET
TAB LOCATION
- Fire Hazard
WARNING
Close the back opening with cover plate (Kit
WE1M454).
Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Failure to do so may result in fire, electrical shock
or lacerations.
Through the rear opening, locate the tab in the
middle of the appliance base. Lift the tab to about
45°,
using a flat-blade screwdriver.
5LJKW
(electric
models
only)
Left
Bottom
5HPRYHGHVLUHG
knockout (one only)
5HPRYH
screw
and save
BEND TAB
UP 45
o
Not for gas
Preassemble 4” elbow with 4” duct. Wrap duct
tape around joint.
Insert duct assembly, elbow first, through the
side opening and connect the elbow to the dryer
internal duct.
Be sure not to pull or damage the electrical wires
inside the dryer when inserting the duct.
Portion “A”
5LJKWHOHFWULF
models only) or
left side exhaust
Fixing hole
Left
5LJKW
Exhaust can
be added to
right (electric
models only)
or left side
Duct
tape
Left
Left
5LJKW
5LJKW
