4
Removing freezer handle
Removing handle may be necessary
when transporting unit through tight
spaces or when reversing door.
➢
Remove handle screws with Phillips
screwdriver.
• Retain screws for later replacement.
Removing fresh food
front-mounted handle
➢
Remove top handle
trim by removing top
handle screw.
• Retain trim and
screw for later
replacement.
➢
Pry bottom handle trim from
handle with screwdriver flat
blade wrapped in masking
tape.
• Retain trim for later
replacement.
➢
Removing two remaining
handle screws and
remove handle.
• Retain screws for later
replacement.
How to replace the
doors and hinges
➢
Install hinge assemblies:
• Install top hinge loosely with
5
⁄
16
" hex
head screws.
• Install center hinge with Phillips
screws.
• Install bottom hinge with
3
⁄
8
" hex head
screws.
➢
Insert bottom hinge pin (select models)
• Locate bottom hinge hole closest to
outside edge of cabinet, and insert
bottom hinge pin. Replace any door
shims, if present.
➢
Place hinge side of freezer door on
bottom hinge pin and hold freezer
door upright while installing center
hinge pin with
5
⁄
16
" hex head driver.
• Replace any applicable door shims.
• Make sure the hinge pin fit is tight.
➢
Place hinge side of refrigerator door
on center hinge pin.
➢
While holding refrigerator door
upright, tighten down top hinge with
5
⁄
16
" hex head driver and replace hinge
cover.
How to level your
refrigerator
If your refrigerator requires an ice maker
water supply connection, proceed to How
to Connect the Water Supply section,
before leveling your refrigerator.
To protect personal property or unit
from damage, observe the following:
➢
Protect soft vinyl or other flooring
with cardboard, rugs or other pro-
tective materials.
➢
Do not use power tools when per-
forming leveling procedure.
CAUTION
MATERIALS NEEDED:
•
3
⁄
8
" hex head driver
• Level
➢
Move the refrigerator to final location
and plug the power
cord in.
➢
Remove toe grille
and bottom cover.
➢
Turn adjustment screws
on the left and right side to raise or
lower front of refrigerator.
• Make sure refrigerator cabinet is
level from side to side by adjusting
left and right roller adjustment
screws.
• Turn stabilizing leg clockwise until
firmly against floor.
Roller
Adjustment
Screw
Stabilizing
Leg
➢
Using a level, make sure front of refrig-
erator is
1
⁄
4
" (6 mm) or
1
⁄
2
bubble higher
than the back of the refrigerator.
➢
Replace toe grille and bracket cover.
See markings on inside of toe grille to
insure proper placement.
• Snap bottom portion into place
first. Press down on top of grille
until top portion snaps into place.
