GE GTE15 Series, Use And Care Manual

Page: 19 / 92

19
Troubleshooting
Introductio
n
Know your Refrigerator
nOtE: It’s important that once you have completed the above steps you make sure that
the water cylinder is correctly installed to prevent water freezing in the cylinder’s interior.
CautiOn: Only fill with drinking water.
REMOVaL OF iCE
1. After a while, your ice cubes will be ready for
use. To remove them, pull the handle slowly
towards you until it’s fully down. At this point
it will be necessary to pull the handle a little
more forcefully until you hear the ice fall into
the lower compartment of your SMART FILL ICE
FACTORY.
2. This compartment can hold up 3 complete
releases of the ice-tray. To remove the ice,
simply lift and pull the storage box that you will
find in the lower part. This box is designed to be
brought wherever you wish. To make more ice,
repeat the process.
nOtE:
The cylinder can only hold one
load at a time. Before repeating the
process, make sure that the tray is empty.
nOtE:
The ice produced may vary in
size.
CLEaninG YOuR sMaRt FiLL iCE FaCtORY
When cleaning your Smart Fill Ice Factory it is imperative that you only use a soft sponge
with water and a neutral soap. Afterwards, leave it to dry.
DO NOT use a steel wool sponge or detergent to clean the SFIF (especially the ice-bucket), as
this could affect how it works, change how it looks, and affect the flavour of your ice cubes.
CLEaninG tHE CYLindER
Only use a soft sponge with water and a neutral soap to clean. Afterwards, leave it to dry.
Don’t use steel wool sponges or detergents, knives or forks as these could scratch or damage
the central valve. If there’s frozen water inside the cylinder, let it melt or use tepid water to
speed up the process.
iMPORtant:
When removing the ice cubes,
pull the handle all the way down. You will feel
resistance at this point, but you need to pull
a little more so that the ice-tray twists and
releases the ice into the lower compartment.
Once this point has been reached, the process
is complete.