GE GSD2900 Series, Use And Care Manual

Page: 8 / 24

THE SYSTEMS MONITOR
TELLS YOU IF ARE WRONG
DISPLAY
and
RESET
SLOW
DRAIN
BLOCKED
DRAIN
DRAIN
SENSOR
SENSOR
WHAT IT MEANS
Electrical power to the dishwasher
has been interrupted but is now
back on.
The dishwasher is taking longer
than normal to drain the water
out. This is usually caused by a
blockage in the drain air gap (see
Air Gap section), a kink in the drain
hose, or a stopped-up drain pipe.
Similar to drain. This
indicates that the drain is so
clogged that the dishwasher
cannot continue to operate in a
satisfactory manner. Dishwasher
will stop.
Dishwasher will continue cycle
along with a drain period.
The temperature sensor in the
dishwasher is not functioning
properly. Dishwasher may
continue to be used, but it
not heat water automatically.
WHAT TO DO
IF DISHWASHER WAS IN USE WHEN THE POWER
FAILURE OCCURRED:
1. Unlatch the door. If the detergent cup is open, add
detergent and the cup.
2. the door and touch “START,” then immediately
touch “CLEAR RESET.” (This will pump any remaining
water out of the machine.)
3. Select the desired cycle and rerun the load.
IF THE DISHWASHER WAS NOT USE:
1. Latch door.
2. Select desired cycle.
3. Run cycle when desired.
This dishwasher is designed to automatically compensate
for longer than
drain times, but cycle time will be
extended. If this code continues to appear frequently:
1. Clean the air gap (See Air Gap section).
2. Check for a kink in the drain hose.
3. Check plumbing for slow or stopped-up drains.
(NOTE: Warranty service does not cover household
drain problems.)
Locate and remove the blockage in the drain system.
To pump any remaining water out of the machine:
1. Latch door.
2. Select any cycle.
3. Touch “START” and then immediately touch “CLEAR
RESET.” (NOTE: Warranty service does not cover
household drain problems.)
If DRAIN SENSOR repeats for the next cycle, call for service.
The temperature sensor needs to be replaced. Call for service.
NOTE: You may continue to use your dishwasher. For best
results adjust your household water heater thermostat to
8