Chapter 3. Installation
16
PACSystems PROFINET Managed Industrial Ethernet Switches User Manual
GFK-3030
3.8
Console Connection
The Console port, located on the bottom panel (Figure 16), is intended for administrative functions, and its use
is optional. It uses a terminal emulator or a computer with terminal emulation software, connected as follows:
•
DB9 connector connected to computer COM port
•
Baud rate: 115,200bps
•
8 data bits, 1 stop bit
•
No parity
•
No flow control
Figure 16: Console Port
To connect the host PC to the Console port, an RJ45 (male) connector-to-RS232 DB9 (female) connector cable
is required. The RJ45 connector of the cable is connected to the Console port of GLM Series; the DB9
connector of the cable is connected to the PC COM port. The wiring for this cable is shown in Figure 17.
Figure 17: Console Cable Wiring
Caution
Console connections should not be permanent. Once any administrative functions
have been performed, disconnect the PC used for that purpose. Leaving a
computer connected would expose the application to security risks. Refer to the
PACSystems RXi, RX3i, RX7i and RSTi-EP Controller Secure Deployment Guide,
GFK-2830.
Refer to Appendix A,
Command Language Interface (CLI)
, for related commands and syntax.
Summary of Contents for GLM064
Page 137: ......
