6
Installation Instruction
STEP 2 – ADJUST LEVELING LEGS
•
Move the dishwasher close to the installation location
and lay it on its back.
•
Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base, 1/4”
less than installation height.
Adjust to
Installation
Height
Adjust to
Installation
Height
STEP 3 – REMOVE TOEKICK
•
Remove the 2 toekick screws. Lift off the 2 piece toekick.
NOTE:
You may have to open the dishwasher door to
access the toekick screws.
2-Screws
STEP 4 – INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
Recommended power cord length is 54” min. and 64” max.
Connect incoming power cord white (or ribbed)
to dishwasher white. Black (or smooth) to black. Ground
to dishwasher green wire. Use UL Listed wire nuts of
appropriate size. Replace junction box cover. Be sure wires
are not pinched under the cover.
White
Ground
Black
Check that white, black and
green dishwasher wires are threaded
through hole in back
Remove
junction box
cover
Insert power
cord wires through
strain relief
and tighten
Use UL Listed
wire nuts
A
C
B
D
Replace
junction box
cover
E
STEP 5 – INSTALL 90° ELBOW
•
Wrap 90° elbow with thread seal tape on both threads.
•
Install a 90° elbow onto the water valve.
•
Do not over tighten 90° elbow, water valve bracket could
bend or water valve fitting could break.
•
Position the end of the elbow to face the rear of the
dishwasher.
90
Elbow
Fill
Hose
Thread
Seal Tape
Water
Valve
Bracket
°
CAUTION:
Dishwasher may tip forward if the door is opened.
PRECAUCIÓN:
El lavavajillas se puede caer hacia delante si la puerta es
abierta.
