7
Consumer
S
uppor
t
Tr
oubleshooting
T
ips
Operating
Instructions
Safety
Instructions
Options
The light above the selected pad will be
ON
to indicate which
OPTION
has been selected.
HOT START
For use with heavily soiled and/or dried-on, baked-on soils. This option
MUST
be
(on some
selected
PRIOR
to starting the cycle.
This option will improve both wash and dry
models)
performance. This option adds 20 minutes to the cycle time.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
HEATED DRY
Shuts off the drying heat option. Dishes air dry naturally and energy is saved.
Light OFF
For faster air dry you can prop the door open after the
CLEAN
light illuminates.
HEATED DRY
Turns the heater on for fast drying. This will extend the total run time by 38 minutes.
Light ON
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
LOCK
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
(on some
Children cannot accidentally start dishwasher by touching pads with this option
models)
selected.
To LOCK the dishwasher control,
touch and hold the
HEATED DRY
pad for 3 seconds. The light below
the
HEATED DRY
pad will turn on.
To UNLOCK the dishwasher control,
touch and hold the
HEATED
DRY
pad for 3 seconds. The
LOCK
light will turn off.
HOT WASH
When selected, the cycle will run longer with the heating element on to improve both
wash and dry performance.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
DELAY HOURS
You can delay the start of a wash cycle for 2, 4 or 8 hours (delay time options may
vary by model). Touch the
DELAY HOURS
pad to choose the number of hours you want
to delay the start of the cycle; then touch
START/RESET
one time. The dishwasher will
count down and start automatically at the correct time.
Touching
START/RESET
a
second time will cancel the
DELAY START
selection
.
RESET
To change a cycle after washing starts, touch the
START/RESET
pad to cancel the
cycle. The
START/RESET
light will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
Start
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
START/RESET
pad once to begin the cycle. Water begins to fill the dishwasher, and approximately 60
seconds later the wash action begins. Touching the
START/RESET
pad a second time will cancel the
cycle and cause the water to drain out. This will take approximately 2 minutes.
NOTE:
The dishwasher remembers your last cycle so you don’t have to reprogram each time. When
the dishwasher door is fully closed, the control panel lights will display the last settings you selected.
If you don’t want to change any of the settings, simply touch the
START/RESET
pad once to begin
the cycle.
If the door is closed, the indicator lights will turn off if the
START/RESET
pad is not pressed within two
minutes. To activate the display, open and close the door or touch any pad.
Also, if a power failure occurs,
NORMAL
and
HEATED DRY
will automatically be programmed.
3
4