Start/Reset
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
START/RESET
pad to begin the cycle. The water fill begins immediately, and approximately 60 seconds later
the wash action begins.
When the dishwasher door is fully closed and latched, the control panel lights will display the last settings
you selected. If you don’t want to change any of the settings, siimply touch the
START/RESET
pad to begin
the cycle.
If the door is closed, the indicator lights will turn off if the
START/RESET
pad is not selected within 5 minutes.
To activate the display, open and close the door or press any pad.
DELAY HOURS
You can delay the start of a wash cycle for up to 6 hours. Press the
DELAY START
pad to choose the number of hours you want to delay the start of the cycle; then
press
START/RESET
.
The machine will count down and start automatically at the correct time.
NOTE:
To cancel the
DELAY START
selection before the cycle begins, repeatedly press the
DELAY START
pad until the display is blank.
RESET
To change a cycle after washing starts:
Touch the
START/RESET
pad to cancel the cycle. The
START/RESET
light will flash while
the water is pumped out, if needed. This takes approximately 2 minutes.
Time Remaining Display
(on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The display
may adjust the remaining time while the
SENSING
light is on. The time displayed at the start of each
cycle may change from the factory setting as the unit customizes itself to home use. During a delay
start, the display will show hours of time remaining until the cycle starts.
Clean
The
CLEAN
light is illuminated when the selected cycle and enhancements are complete. The light will
stay
ON
until a pad is pressed or the door is opened and then closed.
5
4
3
5
Consumer
S
uppor
t
Tr
oubleshooting
T
ips
Operating
Instructions
Safety
Instructions
ge.com