– 62 –
Fault Codes
Fault Code
Description
Problem
Possible Cause/Action
E22
Fill timeout -
1R¿OOVORZ¿OO
Fill time exceeds 8
minutes.
• Ensure manual water supply valves are
fully open.
• Inspect inlet hoses for kinks/obstructions.
• Inspect water valve screens for restriction.
• Check water valve functions – t06
If above steps do not clear the problem
replace solenoid water valve.
E23
Flood protect
drain
In run state, any
WLPHWKHRYHUÀRZEH
detected
• Check water valve functions –t06
• Check water sensor functions – t06
•
2ȺEDODQFHORDGVZLWKKHDY\YLEUDWLRQFDQ
cause code - retry before replacing any
component.
E31
Drain timeout
Slow drain
• machine
will
have water
• not
full.
• Check drain pump - t05.
• Check drain pump for restriction.
• Check for drain restriction.
• Drain height over 96-in. can cause code.
E38
Dispenser error
Correct reservoir
is not found and 8
switches are seen
when motor is
running.
• Check dispenser - t12 (Note: Do not unplug
connectors from dispenser motor unless
replacing.)
E39
Dispenser timeout No switches found in
45 seconds.
• Check dispenser - t12 (Note: Do not unplug
connectors from dispenser motor unless
replacing.)
E42
Drive motor
• Instantaneous
current
Motor excess current
draw.
• Check drive motor - t10 tumble, t11 spin,
t13 spin
• Power down (unplug) washer, wait 30
seconds and retry. If code reoccurs, check
drive motor windings. If motor windings
OK, replace inverter. (There may be a
burned spot on the inverter.) (NOTE:
Cannot occur with open motor winding.)
