
19
Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1.
In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) for proper
washer operation.
2.
In an area where it will come in contact with curtains or
drapes.
3.
On carpet. The floor
MUST
be a hard surface with
a maximum slope of 1/2
s
per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE:
If floor is in poor condition, use 3/4
s
impregnated
plywood sheet solidly attached to existing floor covering.
*
NOTE:
With Legs:
40 1/2” (102.5 cm) - (3/4” (1.9 cm) adjustability)
With Built-In Pedestal™:
46” (117 cm) - (3/4” (1.9 cm) adjustability)
With Optional Pedestal (GFXP1308):
52” (132.1 cm) - (3/4” (1.9 cm) adjustability)
Stacked:
78 1/4” (198.8 cm)
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0
s
(0 cm)
• When installed in closet: Sides, Rear,
Top = 0
s
(0 cm), Front = 1
s
(2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm), located 3
s
(7.6 cm) from top and bottom of door
ROUGH-IN DIMENSIONS
FRONT
39”*
(99cm)
35”
(88.9cm)
28”
(71.12cm)
SIDE
46”*
(117cm)
39”*
(99cm)
46”*
(117cm)
Built-In
Pedestal™
models
only
54 3/8”
(138.2cm)
Summary of Contents for GFWR4800
