Connection Diagrams
Connections are for three-phase
enclosed contactors, across-the-line
starters, and combination starters.
NOTE: For line voltage control, con
nect wire to Ll as shown. For separate
control (where coil voltage and motor
voltage are different) connect this wire
to the separate control source.
RED
BLACK
Figure 7. START-STOP or ON-OFF push button.
WHITE
BLACK
OFF
Figure 8. OFF-ON selector switch.
WHITE
RED
BLACK
Figure 9. H-0-A or 0-0-A selector swttch.
3
r
�
11
r r
M-Line Contactor
r
See Note at left
Customer to remove
this wire if present
on starter.
3
--,
L1
\
\
\
1 1
I I
M-Line Contaclor
See Note at left
t
Customer lo remove
this wire if present
on starter.
1 1
1 I
r
r
-:..::;
"i: :-..;, Maintained Contact
I
1-0,
l-<)J
I
Pilot Device and Wiring
L- _____ _, to be furnished by Customer.
These Instructions do not purport to cover all details or variations Jn equipment nor to provide for every possible contingency
lo
be met In connection with lnstal/atlon, operation, or
malnte-nance. Should particular problems arise which are not covered sufllclently for the Purchaser's purposes, the matter should be referred
lo
the nearest ABB sales office.
—
ABB Inc.
305 Gregson Drive
Cary, NC 27511.
electrification.us.abb.com
—
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With
regard to purchase orders, the agreed
particulars shall prevail. ABB Inc. does not
accept any responsibility whatsoever for
potential errors or possible lack of
information in this document.
We reserve all rights in this document and
in the subject matter and illustrations
contained therein. Any reproduction or
utilization of its contents – in whole or in
parts – is forbidden without prior written
consent of ABB Inc.
Copyright© 2019 ABB
All rights reserved
—
GE is a trademark of GE. Manufactured
by ABB Inc. under license from GE.
1SQC910001M0201
GEH-4763C,
January 2020
3
