• lift the instrument by the base unit.
To make it easier to move Fraction Collector Frac-950 on the laboratory bench, first lift
the front (approx. 30°) and tilt the unit until the rubber feet clear the bench. Then move
the unit to the desired location.
3.3
Unpacking
Check for damage
Check the equipment for damage before starting assembly and installation. There are
no loose parts in the transport box. All parts are either mounted on the system or located
in the accessory kit box. If any damage is found, document the damage, and contact
your local GE Healthcare representative.
Unpack the system
Remove straps and packing material. Then set the equipment upright before starting
installation.
3.4
Assembly
The following parts must be added to the Fraction Collector Frac-920 and Frac-950 in-
strument before it can be used:
• Tube rack
• Collection tubes
• Tubing
• Waste tube
3.5
Connections
Communication
Make sure that UNICORN control software is installed on the computer.
Connect the Fraction Collector Frac-920 and Frac-950 according to the electrical
drawings in electrical and communication connections for Fraction Collector Frac-920
or electrical and communication connections for Fraction Collector Frac-950, respectively.
26
Frac-920 and Frac-950 Operating Instructions 28-9622-09 AC
3 Installation
3.2 Transport
