GE ETS series, Technical Service Manual

Page: 16 / 36

– 14 –
Cut Cut
Here Here
Cut
Here
GEA01108
OLD EVAPORATOR
Copper Copper
Evaporator Evaporator
Lines
Copper
Evaporator
Lines
Cut Cut
Here Here
Cut
Here
Cut Cut
Here Here
Cut
Here
Cut Cut
Here Here
Cut
Here
Aluminum Aluminum
Evaporator Tubes Evaporator Tubes
Aluminum
Evaporator Tubes
Aluminum Aluminum
Evaporator Tubes Evaporator Tubes
Aluminum
Evaporator Tubes
NEW EVAPORATOR
Copper Copper
Evaporator Evaporator
Lines
Copper
Evaporator
Lines
Defrost Defrost
Thermostat Thermostat
Here Here
Defrost
Thermostat
Here
1-1/8 inch
1-1/8
inch
Note: Evaporator drain probe assists in defrosting
drain. During assembly, probe must be installed on
evaporator and in drain to prevent drain from
freezing closed.
8. Install a replacement dryer.
9. Evacuate and recharge the system using
currently accepted procedures.
Evaporator Fan
1. Remove the evaporator cover (see Air tower
and Evaporator Cover procedure).
2. Disconnect the fan motor connector.
3. Carefully pull the fan off the shaft.
4. Remove 2 screws and fan assembly.
5. Remove fan motor.
Note: The position of the fan blade in relation to
the shroud is critical. Refer to figure below for
specifications.
5/16" ± 0.03
Blade tip
1.0" ± 0.05 Target
Motor
Air Flow
Orifice
GEA01149
Condenser Fan
1. Remove the machine compartment cover.
2. Disconnect the fan motor connector.
3. Carefully push the fan off the motor shaft.
Airflow