GE Druck DPI 150, User Manual

Page: 3 / 22

Druck DPI 150 User Manual
i K344 Issue No. 2
General Introduction
This manual provides operating instructions for the DPI 150 Pressure
Indicator compatible with the requirements of operating the instrument.
Safety
The manufacturer has designed this equipment to be safe when operated
using the procedures detailed in this manual. The user must not use this
equipment for any other purpose than that stated.
This manual contains safety and operating instructions that must be
followed to make sure of safe operation and to keep the equipment in a safe
condition. The safety instructions are either warnings or cautions issued to
protect the user and the equipment from injury or damage. Use suitably
qualified personnel and good engineering practice for all procedures in this
manual.
Pressure
Do not apply pressure greater than the maximum working pressure stated
in the specification.
Technical advice
For technical advice contact the manufacturer or subsidiary.
Supervisor Security for the Druck DPI 150
GE strongly advise protection of the set-up menus in this equipment.
Unauthorised access to the supervisor and calibration menus can result in
degraded performance, incorrect settings and inaccuracies. The factory set
PIN are as follows:
Supervisor set-up - 0268 press MENU OK
Calibration set-up - refer to Service Manual K382
Codes can be changed to another code of 4 digits; entering 0000 disables
this security facility.
Symbols
The following symbols mark this equipment:
Refer to the manual.
This product meets the essential requirements of the
relevant EC directives.