GE DigitalFlow XGS868i, Programming Manual

Page: 122 / 176

Appendix C. Programming the XGS868i Using PanaView™
112 DigitalFlow™ XGS868i Programming Manual
C.6.1a Volumetric Units
1. Double-click on the desired Volumetric Units for the flow rate display. Table 21 lists the available units.
2. Double-click on the desired Time units for the flow rate display.
3. Double-click on the desired number of Vol Decimal Digits (digits to the right of the decimal point in the volumetric
flow rate display).
C.6.1b Selecting Totalizer Units
1. Double-click on the desired Totalizer Units for the totalized flow rate display. Available units are listed in Table
C-5 above.
2. Double-click on the desired number of Tot Decimal Digits (digits to the right of the decimal point in the totalized
flow rate display).
3. Do one of the following:
•
If
Mass Flow
is
ON
, proceed to Selecting the Mass Flow Units below.
•
If
Mass Flow
is
OFF
, the meter returns to the
Global PROGRAM
window. Click
[Exit Page]
to return to the Site Edit
Menu .
Note:
To activate mass flow, refer to page 110. The following prompts will only appear if mass flow is activated for
both channels.
Table 21: Available Volumetric/Totalizer Units
English Metric
Actual Cubic Feet Actual Cubic Meters
Thousands of ACF Thousands of ACM
Millions of ACF Millions of ACM
Standard Cubic Feet Standard Cubic Meters
Thousands of SCF Thousands of SCM
Millions of SCF Millions of SCM