GE DigitalFlow GS868, Programming Manual

Page: 19 / 171

Programming Site Data 1-11
March 2008
Entering Channel System
Data (cont.)
6.
Use the
[F1]-[F4]
keys to select the Volumetric Time (units for the
volumetric flow rate display).
7.
Use the
[F1]-[F4]
keys to select the Vol Decimal Digits (the desired
number of digits to the right of the decimal point) in the
volumetric flow rate display.
8.
Use the
[F1]-[F4] and
[
→]
keys to select the Totalizer Units.
The abbreviations and definitions of all the available volumetric and
totalizer units are shown in Table 1-2 above. The choices shown on
the option bar in the prompt screen above are determined by the
selection made at the previous
SYSTEM UNITS
prompt screen.
9.
Use the
[F1]-[F4]
keys to select the Total Decimal Digits (the
desired number of digits to the right of the decimal point) in the
totalized flow display.
10.
If Static Density? is set to
NO
in the
ADVAN
submenu, go to
Procedure Options on the next page. Otherwise, proceed as
follows:
a.
Use the
[F1]-[F4]
keys to select the Mass Flow units, listed in
Table 1-3 below.
b.
Use the
[F1]-[F4]
keys to select the Mass Flow Time units.
Table 1-2: Available Volumetric/Totalizer Units
English Metric
Actual Units
ACF = Actual Cubic Feet ACM = Actual Cubic Meters
KACF = Thousands of ACF KACM = Thousands of ACM
MMACF = Millions of ACF MMACM = Millions of ACM
Standard Units
SCF = Standard Cubic Feet SCM = Standard Cubic Meters
KSCF = Thousands of SCF KSCM = Thousands of SCM
MMSCF = Millions of SCF MMSCM = Millions of SCM
Table 1-3: Available Mass Flow Units
English Mass Flow Units Metric Mass Flow Units
LB- Pounds KG - Kilograms
KLB - Thousands of Pounds
MMLB - Millions of Pounds
TONS - Tons Tonnes - Metric Tons