DigitalFlow™ Multipurpose Ultrasonic Liquid Flowmeter Startup Guide (1- and 2-Channel)
29
Chapter 2. Initial Setup
2.7 Exiting the User Program
After the calibration factor entry has been made, the meter will exit the
PIPE
submenu and return to the initial
User
Program
screen.
At the conclusion of the initial setup programming sequence, the following screen appears:
Note:
If you press
[NO]
, the DF868 still retains the newly programmed information. See the
Programming Manual
for
instructions on using the
SAVE
submenu.
Proceed to Chapter 3,
Operation
, for instructions on taking measurements or refer to the
Programming Manual
for
instructions on programming the Model DF868’s advanced features.
PROGRAM
Start
‰
To leave the
User Program
and
begin taking measurements,
press
[EXIT]
.
PROGRAM
status
ACTIV
SYSTM
PIPE
I/O
PROGRAM Start
At the
User Program
screen
shown, press
[F1]
to return to
measurement mode without
saving the file or press
[F2]
to
enter the
SAVE
submenu.
Do you want to SAVE
current selection appears here
No
Yes
