OPM_STS_400_25A_100_1GB_V011
17
GE DE STS: installation and operating manual 1.1 (GB)
Digital Energy
™
Static Transfer Switch
g
3.2 Unpacking
1. Cut the wrapping bands, and remove the shipping box.
2. Immediately after unpacking carefully check the integrity of the equipment. In case you note
recognizable damage,
•
notify the carrier and place of purchase
•
contact the nearest Service Center.
WARNING!
In case of recognizable damage:
DO NOT
connect any voltage to the unit
DO NOT
put the unit into operation
3. Turn the unit into vertical position and place it on a frame. Screw the pedestal of the STS to the
frame.
4. Recycle the packing material in compliance with all applicable regulations.
3.3 Location
•
This STS is intended to be used in a controlled indoor environment and free of conductive
contaminants and protected against animal intrusion.
•
Check for sufficient floor loading capacity.
•
Avoid placing the unit in direct sunlight or near heat sources.
•
It is important that the unit has adequate ventilation. Maintain air movement around and through the
unit. Do not block the air vents.
•
The unit must be placed in a sufficiently ventilated area; the ambient temperature should not exceed
40
°
C (104
°
F).
•
Do not install the STS in an excessively humid environment or near water, relative humidity should not
exceed 90% at 20
°
C (68
°
F).
•
Avoid spilling liquids or dropping any foreign object into the STS.
