GE Digia II, User Manual

Page: 38 / 56

Digia II
User Manual
30
Alarms
Use the Alarms menu ( Figure 19 ) to control the alarm triggers for your Digia II.
Figure 19. Alarms
The menu options include the following:
Alarm #. The current alarm being edited.
Contact alarm. Select how you want the contact to function. Choose one of the following:
• Enable: When the contact alarm is triggered, the record settings defined in this menu item override
any other settings.
• Disable: The contact alarm cannot be triggered.
• Group: When this contact alarm is triggered, all other group alarms are triggered; otherwise, the
alarm behaves as if it were enabled.
Sensor type. Select how the contact function. Choose one of the following:
• NC: The contact is normally closed, and the alarm resets after the period that is set in alarm due.
• NO: The contact is normally open, and the alarm resets according to the period set in the alarm due
period.
• NC Trans: The contact is normally closed, and the alarm does not reset until the contact is
reopened.
• NO Trans: The contact is normally open by default, and the alarm does not reset until the contact is
reclosed.
Alarm frame rate. Select between off, 1, 2, 3, 4, 5, 6, 7.5, 10, 20, and 30 fps.
Alarm quality level. Select between 1 (lowest) to 6 (highest).
Alarm duration. Choose between 1 and 60 seconds.
Alarm to full screen. Check this box if you want the video to go to full screen when an alarm is triggered.
Motion detection. Choose between Disable , Partial , and Full . If you set it to Partial , it will take you into
the motion detection grid (see Activate a motion detection grid on page 22.)
Motion sensitivity. Choose between 1 (lowest) to 9 (highest).
Select EXPORT to Copy Settings
Select DISPLAY to Paste Settings
Digia II Menu - Alarms
<< Alarm 1 >>
Contact Alarm
Sensor Type
Alarm Frame Rate
Alarm Quality Level
Alarm Duration
Alarm to Full Screen
Motion Detection
Motion Sensitvity
Video Loss
Event Buzzer
Email Notification
Disable
NC
10 f/s
6-Highest
05 Sec(s)
Disable
7