Peel off backing to expose adhesive tape and stick
LED modules into place.
Determine how many modules are required for
your application and cut where necessary.
NOTE:
Cuts can be made between any of the LED
modules.
Determine location of where LED modules will be
mounted based on sign dimensions (see chart).
If mounting on bottom of sign, the use of a riser
will be needed (minimum 1/8 in. distance between
bottom surface and module).
3
2
1
4
Layout LED Modules
Sign
Modules mounted to sides
Use rivets, screws, or silicone to secure each
module within the sign. Use #6 (M3) or #8 (M4)
screws, 1/8-inch (3.2 mm) rivets, or silicone.
Components and Tools Required
5
1
2
3
4
UL approved 18 AWG (0.82 mm
2
) supply wire
UL approved 22-14 AWG (0.33-2.08 mm
2
) wire
connectors or 22-18 AWG (0.33-0.82 mm
2
) in-line/
IDC connectors
#6 or #8 (M3 or M4) screws, 1/8 inch
(3.2 mm) rivets or electrical grade silicone
3
2
1
4
Tetra® 12 Volt Power Supply
Tetra® Slim EdgeStrip LED modules
Electrical grade RTV silicone.
Example electrical grade RTV silicones include:
• Momentive RTV 6700 Series Silicone Rubber Adhesive Sealant
• Momentive White Blanc RTV 162 Silicone Rubber Adhesive Sealant-
Electrical Grade
• Dow Corning 3140 - Non-Corrosive Flowable (clear)
• Dow Corning 3145 - Non-Corrosive Nonflowable (clear or gray)
• Dow Corning RTV 748 Non-Corrosive Sealant-White
5
T
C
Measure Point
6
6
2
