February 2009
1-20
Programming Site Data
Entering Analog Outputs
The Analog Output option enables the set up of additional output
parameters. To enter the option, scroll to the Analog Output entry on
the Program Menu (see Figure 1-20 below) and press
[ENTER]
.
Note:
Input/Output Menu options may appear in a different order,
depending on where each option card is installed. Cards are
numbered from right to left.
Figure 1-20: Analog Output Option Window
The screen appears similar to Figure 1-21 below. To step through
each parameter, press the [
T
] key. See the
Program Menu Map
,
Figure 1-35 on page 1-38.
Figure 1-21: Analog Output Window
Transducer
Site Program Meter Logging Service
Pipe
Fluid
Path
Standard Volu
User Functions
Correction Fac
Main Board (0)
0
50
100
AnalogOut(2:B)
AnalogOut(2:C)
AnalogOut(2:D)
AnalogIns (1)
A
Digital Outputs
R
Program
elocity, m/s
IO
Analog Outputs (2)
AnalogOut(2:A)
Span
Data Source
Zero
OK
Cancel
Analog Out
Hold Last
NO UNIT
On Error
0
100
4-20 Out Setup
Off
Summary of Contents for CTF878
