GE Combination GFQ14, Owner'S Manual & Installation Instructions

Page: 7 / 32

49-3000230 Rev 0
7
Getting started
Controls
A Power
Press to “wake up” the display. If the display is active, press to put the unit into standby mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Display and Status Lights
The display shows cycle status (
DRY COOL WASH SPIN
), the Estimated Time Remaining until the end of the
cycle and the options selected. In addition, the display will show:
Controls locked on.
End of cycle signal on.
Door Lock
Door will lock from the start of the cycle until the end of the cool down phase.
NOTE: If an out-of-balance condition is detected by the unit, the SPIN light will blink during the remaining portion of
the cycle and will stay illuminated for a short time after cycle completion. When this occurs, the unit is taking actions
to correct the out-of-balance condition and complete the cycle normally. In some cases, the unit may not be able to
balance the load and spin up to full speed. Run a
Spin Only cycle.
Power Start
Pause
Cold
Cool
Warm
Ex Hot
Hot
No Spin
Low
Medium
Max
High
Ex Light
Light
Normal
Ex Heavy
Heavy
Est Time Remaining
Delay
Wash
Cold
Cool
Warm
Ex Hot
Hot
No Spin
Low
Medium
Max
High
Ex Light
Light
Normal
Ex Heavy
Heavy
Est Time Remaining
Options
Tumble
Time
Saver
Extra
Rinse
Auto Damp Dry Normal
Auto Dry Delicates
Casuals Auto Extra Dry
Spin Only
Stain Wash
With Steam
Whites Timed Dry
Tub Clean Sanitize
add a garment
Soak
Heavy
Duty
Rinse + Spin
Quick
Wash
Dry Temp Soil Spin
Add Dry Time
WASH SPIN DRY COOL
Door Lock
Off
Low
Normal
Delay Ex Tumble
C
J A I B K
D E F H L G
USING THE COMBO W
A
SHER/DR
YER