10
11
Note:
The Zone/Sensor cannot be erased if:
-
The Zone has been triggered for an Alert or alarm. The
Sensor/Zone must be reset.
-
There is loss of signal from the Sensor to the Control
Center (such as low battery, or Sensor is out of range).
-
The system is armed.
The Control Center will sound three beeps to indicate it could
not erase the Zone.
Testing a Sensor or your system
Once all the Sensors have been assigned to Zones
in the Control Center you can now test your system.
Ensure the Control Center can receive the signal
from the intended location of the Sensor before
permanently mounting a Sensor.
Step 1 -
Unplug AC adapter and remove batteries
from the Control Center.
Step -
Press and hold the ‘Mute’ button and plug
the AC adapter back into the Control Center. When
all the LED indicators turn on, release the Mute
button. The Control Center is now in Test Mode and
any Sensor can now be tested in any Zone.
Step -
Set the Notification Mode to ‘Alert’ position
and begin activating Sensors one at a time.
Note:
The sensor has a LED that flashes to show when the
sensor has triggered and transmitted to the Control Center.
Step 4 -
When testing is complete, unplug the AC
adapter, then plug the AC adapter back in and
reinstall batteries. This returns the Control Center
to standard operation mode.
Note:
The Control Center will automatically return to standard
operation mode after 5 hours.
