GE Baker Hughes LUMEN TERRAIN, User Manual

Page: 28 / 37

28
LUMEN TERRAIN User Manual
Chapter 2. Installation
Remove Item 1 from Item 3 along with the red and black cables. Remove Item 5 from Item 3 and insert
that end into the open hole of the Sensor Node enclosure such that Item 4 is on the outside of the
enclosure as shown above. Similar to how the Base Station right angle adapter was installed, Items 5
and 4 will need to be adjusted in a way that the opening of Item 3 faces up once it is hand-tight. Once
hand tight, use a wrench and turn Item 3 one full turn and visually inspect that Item 4 is compressed to
ensure a water-tight connection. Pull the red and black cables from the conduit and through Item 3.
Remove Item 2 from Item 1 and hand-tighten Item 1 into Item 3. Using a wrench, tighten Item 1 by
turning it 1.5 turns to ensure a water-tight connection is made. Reattach Item 2 into Item 1. If Item 1 is
oriented in such a way that Item 2 cannot be attached, c
ontinue tightening Item 1 until there’s enough
clearance for Item 2. Finished installation should look similar to the following figure, with orientation of
Item 2 varying.
For connection to the junction box on the solar panel, follow instructions in Section 2.4.5
–
Conduit
Wiring Connection (Solar Panel End) and for wiring connection, follow the instructions in Section 2.4.5.1
2.5.3.1. Battery and Solar Panel Wiring, Enclosure
Fully insert the red wire from the conduit into the Solar Panel Fuse Assembly as shown in the figure
below. Note that the assembly highlighted in blue is the Solar Panel Fuse Assembly. For the black wire,
remove the Solar Panel Terminal and insert the black wire into the remaining opened port and secure
the wire by tightening the screw terminal. Plug the Solar Panel Terminal back into the PCB into the
position shown in Figure XXX.
The battery end of the Battery Fuse Cable should be connected to the battery connections, under the
Battery Terminal Shield, from the factory. Attach the Battery Terminal to the PCB as shown in Figure
XXX.
Once both green connectors are blocked in, use the supplied 8” cable tie to secure the connections as
shown below and cut off excess length.