49
• Installation
ASTAT-XT main PCB.
Dip switches location, software version label location and PCB hardware version identification.
5.5
Dip Switch Settings on the Main PCB
The dip switch has eight separate switches. It is located under the front cover of the control module (models
QTx0085x-QTx1400) or under the display unit (models QTx0008x-QTx0072).
No.
Switch Function
Switch Off
Switch On
1 Display
format
Minimized
Maximized
2 Not
Used
-
-
3 Mains/generator
Mains
Generator
4 Must
be
OFF
-
-
5
LCD language selection
See tables below section
6
7
Expanded settings
Disabled
Enabled
8 Software
lock
Open
Locked
5.5.1
Switch # 1 – Display Modes
Two display modes are available:
Maximized – display of all possible parameters.
Minimized – display of pre-selected parameters.
Setting switch # 1 to OFF will minimize the LCD displays.
Refer also to section
Maximized Mode - Switch #1 – On
Minimized Mode Switch #1 – Off
Display Only
Main Settings
Start Settings
Stop Settings
Dual Settings
Slow SP & Saving Parameters
Fault Settings
I/O Settings Parameters
COMM. Parameters
Statistical Data
Display Only
Main Settings
Start Settings
Stop Settings
Statistical Data
