ASTAT XL User Manual
Fout! Stijl niet gedefinieerd.
52
DET-812
•
10C
User Screen - Top Right
Default:
Blank
•
10D
User
Screen
- Bottom Left
Default:
Hours Run
•
10E
User Screen - Bottom Right
Default:
Blank
10F – Graph Timebase
Options:
10 seconds (default)
30 seconds
1 minute
5 minutes
10 minutes
30 minutes
1 hour
Description:
Sets the graph time scale. The graph will progressively replace the old data
with new data.
10G – Graph Maximum
Range:
0% – 600%
Default:
400%
Description:
Adjusts the upper limit of the performance graph.
10H – Graph Minimum
Range:
0% – 600%
Default:
0%
Description:
Adjusts the lower limit of the performance graph.
10I – Mains Reference Voltage
Range:
100 – 690 V
Default:
400 V
Description:
Sets the nominal mains voltage for the keypad's monitoring functions. This is
used to calculate motor kilowatts and kilovolt amperes (kVA) but does not
affect the ASTAT XL's motor control or protection.
10J – Display A or kW
Options:
Current (default)
Motor kW
Description:
Selects whether the ASTAT XL will display current (amperes) or motor kilowatts
on the main monitoring screen.
8.4.11
15 Restricted
15A – Access Code
Range:
0000 - 9999
Default:
0000
Description:
Sets the access code to control access to restricted sections of the menus.
Use the
EXIT
and
ENTER
buttons to select which digit to alter and use the
and
buttons to change the value.
NOTE
In the event of a lost access code, contact your supplier for a master access code that allows
you to re-program a new access code.
15B – Adjustment Lock
Options:
Read & Write
(default)
Allows users to alter parameter values in the Programming
Menu.
Read Only
Prevents users altering parameter values in the Programming
Menu. Parameter values can still be viewed.
Description:
Selects whether the keypad will allow parameters to be changed via the
Programming Menu.
15C – Emergency Run
Options:
Disable (default)
Enable
Description:
Selects whether the soft starter will permit emergency run operation. In
emergency run, the soft starter will start (if not already running) and continue
to operate until emergency run ends, ignoring stop commands and trips.
Emergency run is controlled using a programmable input.
