GE and the GE Monogram are trademarks of the General Electric Company and are used under license. Information provided is subject to
change without notice. All values are design or typical values when measured under laboratory conditions, and GE makes no warranty or
guarantee, express or implied, that such performance will be obtained under end-use conditions. © 2019 GE Current, a Daintree company.
www.LED.com
HORT110 (Rev 11/26/19)
Connection Schematic
Connect the light engine to driver prior to powering the driver. Plug together cables between light engine and
driver. For longer distances between light engine and driver, use an inter-connection cable (6 or 12 feet long) to
complete connection.
Electrical products must not be thrown out with domestic waste. They must be taken to
a communal collecting point for environmentally friendly disposal in accordance with
local regulations. Contact your local authorities or stockist for advice on recycling. The
packaging material is recyclable. Dispose of the packaging in an environmentally friendly
manner and make it available for the recyclable material collection-service.
Conforms to the following standards:
RISK GROUP 2 - CAUTION / ATTENTION - RAYONNEMENT LUMINEUX GROUPE 2
Possibly hazardous optical radiation emitted from this product. Do not stare at operating lamp. May be harmful to the eyes.
Le rayonnement lumineux émis par ce produit est potentiellement dangereux. Ne pas regarder la lumière émise
directement car elle pourrait occasionner des dommages aux yeux.
WARNING / AVERTISSEMENT
RISK OF ELECTRICAL SHOCK: Turn power OFF before inspection, installation or removal.
RISQUE DE CHOC ELECTRIQUE: Coupez l’alimentation avant l’inspection, l’installation ou la désinstallation.
Ambient temperature surrounding each driver must be lower than 104°F (40°C). / La température ambiante autour de
chaque module d’alimentation ne doit pas excéder 104°F (40°C).
Visit www.LED.com
Call us today! 1-888-MY-GE-LED
Email us: [email protected]
*White = Neutral or Line 2
*
*
*
Driver
Driver Driver Driver
N
3-Phase Y
REPEAT FOR ENTIRE CIRCUIT BALANCING OUT EACH PHASE
3-Phase ∆
L3
L2
L1
Driver
Driver
Green
Green
Green
Green
Green
Green
Black
Black
Black
Black
Black
Black
White
White
White
White
White
White
Driver Input Wire
Colors
Black = Line 1
White = Neutral or Line 2
Yellow/Green = Ground
Driver
Light engine
AC line
Junction box
Driver bank plate
Use proper circuit
protection level
6’ or 12’ inter-connection cable (Maximum cumulative
length of inter-connection cable is 24 feet)
Plug together
Driver
