– 7 –
Mechanical Assembly and Disassembly
To Service complete
CustomCool
TM
pan and
Component access.
WARNING: MAKE SURE POWER IS
DISCONNECTED!
To Service Components:
1. Remove 1
st
and 2
nd
bin from bottom of
fresh food section.
2. Lift up and out to remove the CustomCool
TM
front chill cover (WR17X10915).
3. Remove two screws in front of CustomCool
TM
lower cover (WR31X10006), two screws on
either side of the pan, and one screw in the
back of the housing.
8. The CustomCool
TM
assembly is now free, slide
assembly to the right to free from refrigerator
wall. A large Styrofoam
TM
insert is located in
the raised end of the upper cover housing,
note position for replacement, it must be
repositioned correctly to reassemble. The
upper cover can be removed, components
exposed.
9. Slots molded into the lower pan hold the fan,
single damper assembly, and dual damper
assembly. Pull up to release and push back
into slot to reassemble.
7.
Remove the freezer grill mullion (must be
removed prior to CustomCool
TM
service),
(WR02X10829) from the freezer side, by
inserting a #2 Phillips screwdriver into the
center of the diverter and turning the screw
counterclockwise. (See illustration below)
4. Remove two screws holding chill water
reservoir assembly to back of refrigerator, and
plastic deflector cover.
5. In the freezer compartment lift up on freezer
baskets to remove (no need to remove rails),
to completely provide access to the lower air
duct cover.
6. Push in on the plastic lower freezer air tower,
and then push up to remove. It is attached by
two tabs one located on the backside of the
freezer and the other rest on the air diverter
asm.
