REMOVE AIR CONDITIONER FROM CASE
Remove the front grille. See the Care and Cleaning
section.
Find the locking plate located on the front
left side.
Remove the screw and the locking plate to unlock
the air conditioner.
Remove and discard the shipping screw
on the back of the air conditioner to allow
removal of the air conditioner from the case.
Pull the bottom corners of the air conditioner
and slide it out of the case.
Remove all shipping pads (if present) inside the air
conditioner next to the compressor.
Remove the rear grille that is taped to the back
of the case. Remove the packet of screws taped
to the back of the grille. While holding the grille at a
45° angle, insert it into the clips at the top of the case
and push the bottom in. Keep slight upward pressure
on the grille until it fits flush with the bottom of the
case.
17
STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt towards the outside and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the stool.
WOOD PIECES
WIDTH:
2
″
LENGTH:
Long enough to fit inside the window frame.
THICKNESS
:
To determine the thickness, place a piece
of wood on the stool to make it 1/2
″
higher than the top
of the storm window frame.
Attach securely with nails or screws provided by
the installer.
2
1/2
″
higher
than frame
Storm
window
frame
Stool
Sill
Wood
3
A
B
C
Locking
plate
Remove
screw
D
Remove
screw
E
F
If attaching the grille
from the outside of the
case, use the 2 long screws.
If attaching the grille
from the inside of the case,
use the 2 short screws.
G
Clips
Insert the 2 long screws
on the outside
Insert the 2 short screws
on the inside
Installation Instructions
Remove shipping pads
(if present)
