Safety Instructions
Operating Instructions
Car
e and Cleaning
Installation Instructions
Tro
u
b
le
shooting Tips
Consumer S
uppor
t
5
GEAppliances.com
COOL MODE
Remote Control
1. Press
COOL
pad.
2. Press
LOW
,
MED
or
HIGH
pads to set desired fan
speed.
3. Press the
IN / DECREASE –
pads to set
the desired temperature 60°F to 85°F in 1°F
increments.
Control Panel
1. Press the
MODE
pad until the
COOL
indicator light is lit
and the
LOW
,
MED
or
HIGH
indicator light is lit for the
desired fan speed.
2. Press the
IN / DECREASE –
pads to set the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature.
The compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler.
Set the thermostat at a higher number and the indoor air
will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to
COOL
, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
COOL
mode and
HIGH
or
MED
fan with a middle set temperature.
For Maximum Cooling—
Select the
COOL
mode
and
HIGH
fan with a lower set temperature.
For Quieter and Nighttime Cooling—
Select the
COOL
mode and
LOW
fan with a middle set temperature.
NOTE: If you switch from a COOL setting to OFF or to
a fan setting, wait at least 3 minutes before switching
back to a COOL setting.
FAN MODE
Use the
FAN
mode to provide air circulation and filtering
without cooling. Since fan-only settings do not provide
cooling, a temperature setting will not be displayed.
Remote Control
Press
FAN
pad. Press
LOW
,
MED
or
HIGH
pads to set
desired fan speed.
Control Panel
Press the
MODE
pad until the
FAN
indicator light is lit
and the
LOW
,
MED
or
HIGH
indicator light is lit for the
desired fan speed.
