GE AHE24 Series, Owner'S Manual & Installation Instructions

Page: 4 / 32

4
49-5000624 Rev. 0
USING THE
AIR CONDITIONER
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
Remote Control
Air Conditioner Controls
Auto
Cool
Speed
Mode
Med High
Fan Eco
_
+
Heat
Low
Filter
Reset
Delay
Sleep
Mode
1 2 3 4
5
8 7
6
Controls
Power
Speed
Mode
Eco Delay
1
4
5
6
3
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
2. Display
Shows the room temperature in Fan mode. Shows the
Set temperature while setting the temperature in Cool,
ECO or Heat modes.
7HPSDQG'HOD\,QFUHDVHޔ'HFUHDVHޕ pads
8VHWRVHWWHPSHUDWXUHRUGHOD\WLPH7HPSHUDWXUHFDQ
be set in Cool, ECO or Heat mode.
4. Mode Pad
8VHWRVHWWKHDLUFRQGLWLRQHUWR Cool, Fan, Eco or
Heat mode.
5. Fan Speed Pad
In Cool, ECO or Heat
PRGH8VHWRVHWWKHIDQVSHHG
to Auto, High, Med or Low on the unit.
In Fan PRGH8VHWRVHWWKHIDQVSHHGWR High, Med,
or Low on the unit.
6. Delay Pad
Delay ON— When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF— When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad. Each touch of the Increase
ޔ'HFUHDVHޕ pads will set the timer in 1-hour
intervals.
To review the remaining time on the Delay timer, press
WKH'HOD\8VHWKH ,QFUHDVHޔ'HFUHDVHޕ
pads to set a new time if desired.
To cancel the timer, press
'HFUHDVHޕ
pad until the
set time is --.
7.
6OHHS3DGVHWE\DLUFRQGLWLRQHUFRQWUROVRQO\
The Sleep mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The
Sleep mode is available only in Cool, Heat and
Fan only settings.
Press the Sleep mode pad and its light will
illuminate. The fan indicator will stay at the same
setting but the air conditioner will automatically
change the
Fan speed to low in either Cool, Heat or
Fan only mode.
In Fan only mode, the fan will stay in the Low speed
setting for 8 hours. After 8 hours, the air conditioner
will turn off.
In Cool mode, the fan will stay in the Low speed
setting for 8 hours from the time the Sleep mode
pad was pressed. The air conditioner will also
raise the set point 2
° F in 30 minutes and 2 ° F more
in another 30 minutes where it will remain for the
QH[WKRXUV$IWHUKRXUVWKHDLUFRQGLWLRQHUZLOO
turn off.
In Heat mode, the fan will stay in the Low speed
setting for 8 hours from the time the Sleep mode
pad was pressed. The air conditioner will also
lower the set point 2
° F in 30 minutes and 2 ° F more
in another 30 minutes where it will remain for the
QH[WKRXUV$IWHUKRXUVWKHDLUFRQGLWLRQHUZLOO
turn off.
While the unit is in Sleep mode, pressing any pad
will return it to the settings that were in place before
the
Sleep mode pad was pressed.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the air filter (refer to
page 6), place it back in the front panel, and press the
Filter Reset pad. The light will go off.