Safety Instructions
Operating Instructions
Care and Cleaning
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
Preparing to install the air conditioner.
Read these instructions completely and carefully.
NOTE TO INSTALLER:
Leave these instructions
with the air conditioner after installation is
completed.
NOTE TO CONSUMER:
Keep Owner’s Manual
and Installation Instructions for future use.
CAUTION:
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Do not change the plug on the power cord of
this air conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
IMPORTANT NOTES:
For personal safety, this air conditioner must be
properly grounded.
It is important to have the wall outlet and circuit
checked by a qualified electrician if there is any
doubt as to whether a proper ground exists.
Follow National Electric Codes (NEC) and/or
local codes and ordinances.
Power cord includes a current interrupter
device. A test and reset button is provided on
the plug case. The device should be tested on a
periodic basis by first pressing the
TEST
button
and then the
RESET
button. If the
TEST
button
does not trip or if the
RESET
button will not stay
engaged, discontinue use of the air conditioner
and contact a qualified service technician.
Before You Begin
Some models require 115/120-volt a.c.,
60 Hz grounded outlet protected with
a 15-amp time delay fuse or circuit
breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall
outlet you plan to use is only a 2-prong outlet,
it is your responsibility to have it replaced with
a properly grounded 3-prong wall outlet.
Some models require 230/208-volt
a.c., protected with a time delay fuse
or circuit breaker. These models
should be installed on their own single
branch circuit for best performance
and to prevent overloading house
or apartment wiring circuits, which
could cause a possible fire hazard
from overheating wires.
Electrical Requirements
■
Screwdrivers
■
Ruler or tape measure
■
Scissors or knife
■
Pencil
■
Level
■
Drill and 1/8
″
bit
Tools You Will Need
Open the inlet grille and remove the filter.
See the
Air Filter
section.
Secure the front grille frame with the two
screws packed with the Owner’s Manual.
Replace the filter and close the inlet grille.
C
B
A
Before Installing the Air Conditioner
Inlet grille
7
