For Normal Cooling
For Maximum Cooling
1. Set the Selector Switch at HI COOL.
1. Set the Selector Switch at HI COOL.
2. Set the Thermostat Control at the desired number
2. Turn the Thermostat Control to 6.
(usually 3
is a good starting position).
3. Set the Ventilation Control at CLOSED.
temperature is not satisfactory after a reasonable time,
set the Thermostat Control
higher number for a
cooler room or at a lower number for a warmer mm.
3. Set the Ventilation Control at CLOSED except for
brief periods when you want to exhaust room air to
the outside.
For Quieter Operation
1. Set the Selector Switch at LO COOL position.
3. Set the Ventilation Control at CLOSED.
2. Turn the Thermostat Control to the desired number.
When the Thermostat Control is set on 5 or 6 and
the Fan is set on low speed, moisture may freeze on
the coils and prevent the unit from cooling. If this
happens, set the Fan at high speed and set the
Thermostat Control to a lower number.
For Nighttime Operation
For Extreme Temperatures
During the cooler evening hours, we recommend
For greatest economy and best
we
that you set the Selector Switch at LO COOL for
suggest you set the Selector Switch at HI COOL
very quiet operation and the Thermostat Control
in extremely hot weather.
at mid-range (3 or 4). Set the Ventilation Control
at CLOSED.
To Adjust Air Direction
Up and
Side to side
banks of
air direction louvers
are controlled
fingertip pressure on the louvers.
They regulate air discharge upwind or straight out.
Two banks of side-to-side air direction louvers are
controlled by tabs that let you position each bank
separately to discharge air-to
right, to the left, or
straight ahead.