GE ADHL22, Owner'S Manual

Page: 4 / 24

49-5000545 Rev. 0
OPERA
TING INSTRUCTIONS
Controls
Delay On/Off
indicator lights
3RZHU2Q
indicator
light
&OHDQWKH)LOWHU
indicator light
High, Medium,
/RZDQG6PDUW
Dry indicator light
Appearance may vary by model.
Other Features
Alarm
,IWKHEXFNHWLVIXOORUPLVVLQJDQDODUPZLOOVRXQGIRUDERXW
seconds to remind you to empty and replace the bucket.
Power Outage
In the case of a power outage or interruption, the unit will
automatically restart, in the settings last used, after the power
is restored.
Auto Shut Off
7KH:DWHU/HYHO&RQWURO6ZLWFKVKXWVRIIWKHGHKXPLGLILHU
when the bucket is full, or when the bucket is removed or not
replaced in the proper position.
NOTE: 7KHIDQPRWRUDQG
compressor will stop as soon as the bucket is removed. An
alarm will sound if the water level switch is not reset.
Auto Defrost
When frost builds up on the evaporator coils, the compressor
will cycle off and the fan will continue to run until the frost
disappears.
Controls
NOTE: When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
3UHVVWRWXUQWKHGHKXPLGLILHURQDQGRII
2. Fan Speed Pad
Controls the fan speed.
3UHVVWRVHOHFLJK0HGLXP/RZRU6PDUW'U\IDQVSHHG
Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
SUHIHUUHGVHWWKHIDQFRQWUROWR0HGLXPRU/RZ
Smart Dry compares the set humidity level with the actual
humidity and adjusts the fan speed automatically.
3. Display
Shows the set % humidity level while setting, then shows the
actual (+/– 5% accuracy) room % humidity level.
4. Humidity Set Control Pads
7KHKXPLGLW\OHYHOFDQEHVHWZLWKLQDU
5XPLGLW\WR5+5XPLGLW\LQ
LQFUHPHQWVRULQ1RQVWRSPRGHIRUFRQWLQXRXVRSHUDWLRQ7R
set the unit for continuous operation, press the – pad until
WKH³1RQVWRS´LQGLFDWRUOLJKWLVLOOXPLQDWHG
NOTE: ,I1RQVWRSLVVHOHFWHGWKHGHKXPLGLILHUZLOORSHUDWH
continuously at its maximum dehumidification settings if
attached to a hose to drain or until the bucket is full.
)RUGULHUDLUSUHVVWKH
– pad and set to a lower percent value.
)RUGDPSHUDLUSUHVVWKH
+ pad and set to a higher percent value.
When you first use the dehumidifier, set the humidity control
WRRU$OORZDWOHDVWKRXUVIRUWKHGHKXPLGLILHU
to achieve the humidity level. If you still have damper air
than desired, set the humidity level to a lower setting or
VHOHFW1RQVWRSIRUPD[LPXPGHKXPLGLILFDWLRQ
5. Filter Timer
$IWHUKRXUVRIRSHUDWLRQWKH&OHDQWKH)LOWHULQGLFDWRU
light will glow to remind you to clean the filter. Remove the
filter and clean it.
3UHVVDQGKROG)LOWHUEXWWRQIRUVHFRQGVWRUHVHWWKHILOWHU
reminder. See the Care and Cleaning section.
6. Delay Off
While the dehumidifier is operating press the Delay button.
3UHVVWKH8S$UURZ'RZQ$UURZEXWWRQVWRVHOHFWWKH
number of hours you want the dehumidifier to continue to
operate before turning Off.
NOTE: After displaying the time, the Display will revert to
showing the current humidity after 5 seconds have passed.
3UHVVLQJWKH'HOD\EXWWRQZLOOGLVSOD\WKHQXPEHURIKRXUVOHIW
on the delay.
Delay On
While the dehumidifier is off press the Delay button.
3UHVVWKH8S$UURZ'RZQ$UURZEXWWRQVWRVHOHFWWKH
number of hours you want the dehumidifier to remain off
before turning On.
NOTE: 7KHGLVSOD\ZLOOVKRZWKHQXPEHURIKRXUVOHIWXQWLOWKH
unit turns on.
To cancel the Delay:
3UHVVWKH'HOD\EXWWRQRQFHWKHKRXUVUHPDLQLQJRQWKH
'HOD\ZLOODSSHDURQWKHGLVSOD\3UHVVWKH'HOD\EXWWRQ
again and the Delay will be cancelled.
7. Empty Indicator
7KH³(PSW\´LQGLFDWRUZLOOEOLQNZKHQWKHEXFNHWLVUHDG\
to be emptied, or when the bucket is removed and/or not
replaced in the proper position.