Problem
Possible Causes
What To Do
“Door” appears in the
Self-cleaning cycle has been
•
Move the latch handle all the way to the right.
display
(on some models)
selected but the latch handle
was not moved all the way
to the right.
latch handle was moved to the
•
Move the latch handle to the right only when setting
right but a program other than
the self-cleaning cycle.
self-cleaning was selected.
“F—” and a number or
on models with a door latch,
•
The latch may have been moved, even if only slightly,
letter flash in the display
if a function error code appears
from the locked position. Make sure the latch is moved
(on some models)
during the self-cleaning cycle,
to the right as far as it will go.
check the oven door latch.
you have a function error code.
•
Touch the
Clear/Off
pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats.
•
Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Display goes blank
A fuse in your home may be
•
Replace the fuse or reset the circuit breaker.
(on some models)
blown or the circuit breaker
tripped.
The clock is turned off so that it
•
See the
Using the clock and timer
section.
does not show in the display.
Display flashes
Power failure.
•
Reset the clock.
(on some models)
Unable to get the
oven control pads were
•
The
Bake
and
Broil Hi/Lo
pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
(on some models)
Power outage,
Power outage or surge.
•
Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the
Clear/Off
pad, setting the clock and
(on some models)
resetting any cooking function.
“Burning” or “oily” odor
This is normal in a new oven
•
To speed the process, set a self-clean cycle for a
emitting from the vent
and will disappear in time.
minimum of 3 hours. See the
Using the self-cleaning
oven
section.
Strong odor
An odor from the insulation
•
This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan may automatically
•
This is normal. The cooling fan will turn off and on.
turn on and off to cool
internal parts.
Drawer does not slide
The drawer is out of alignment.
•
Fully extend the drawer and push it all the way in.
smoothly or drags
See the
Care and cleaning of the range
section.
Drawer is overloaded or load
•
Reduce weight. Redistribute drawer contents.
is unbalanced.
48
Before you call for service…
Troubleshooting Tips
O
pe
ra
tin
g
In
st
ru
ct
io
ns
Sa
fe
ty
In
st
ru
ct
io
ns
Ca
re
a
nd
C
le
an
in
g
In
st
al
la
tio
n
In
st
ru
ct
io
ns
Tr
ou
bl
es
ho
ot
in
g
Ti
ps
Co
ns
um
er
S
up
po
rt
