GE 27GT530TX1, Technical Service Data

Page: 3 / 16

ERROR CODES CHART
SET 4666 P SET 4666 P
SET 4666 P SET 4666 P SET 4666 Paaaaaggggge 1
e 1
e 1 e 1 e 1
Err Err
Err Err
Error Code or Code
or Code or Code
or Code
DEC DEC DEC DEC DEC HEX HEX HEX HEX HEX Err Err Err Err Error Location or Location or Location or Location or Location Condition Indicated Condition Indicated Condition Indicated Condition Indicated Condition Indicated
0 00 No error code -
1 01 16.0V fault 16.0V STBY source is failing.
3 03 12.0V run fault 12.0V source is failing.
4 04 T4 Chip Run supply failed.
8 08 T4 Chip X-ray protection caused high voltage shutdown.
9 09 T4 Chip (POR) Power supply problem at (POR) power on reset.
10 0A F2 PIP module error (POR) Power supply problem at (POR) power on reset/PIP.
11 0B Stereo decoder (POR) Power supply problem at reset/Stereo decoder.
16 10 Run IIC Bus held low Run IIC clock or data held low.
18 12 Standby IIC Bus held low Standby IIC clock or data held low.
23 17 Gemstar Board Guide fatal error on set using Gemstar Board.
24 18 Gemstar Board Task monitor error on set using Gemstar Board.
25 19 Gemstar Board Watchdog error on set using Gemstar Board.
34 22 Gemstar Board Gemstar fails to acknowledge.
44 2C F2 PIP module error F2PIP fails to acknowledge.
102 66 Octal DAC Octal DAC fails to acknowledge.
128 80 Stereo decoder Stereo decoder fails to acknowledge.
160 A0 Main or PIP tuner EEPROM Main or PIP tuner EEPROM fails to acknowledge.
186 BA T4 Chip T4 Chip fails to acknowledge.
196 C4 Main tuner PLL/DAC Main tuner PLL IC fails to acknowledge.
198 C6 Main tuner PLL/DAC Main tuner DAC IC fails to acknowledge.
ERR ERR
ERR ERR ERROR CODES
OR CODES
OR CODES OR CODES OR CODES
If certain failures occur, the matching error codes will be stored in the EEPROM. These error codes will be displayed in parameters 1, 2, and 3. The first failure error code
will be stored at parameter 1 and the second failure error code will be stored at parameter 2. Parameter 3 will be updated to display the most recent failure occurred in the
chassis. If a failure of a bus IC occurred, the normal acknowledgment checking of that bus will be disabled in the service mode and the address of that IC which failed will
be stored in one of the error code parameters. After every repair is done to the chassis it is recommended to check the error code parameters, and reset them back to value 0.