6
Programming Your Remote
Your GE universal remote control is designed to
control multiple audio/video devices such as a TV,
DVD, DVR, satellite, cable and audio device using
only one remote. To use this remote, you will need to
program it to control the devices of your choice. There
are two ways to program the remote - direct code
entry or auto code search.
Direct Code Entry (Recommended)
1. Locate the Remote Code List provided
in this manual. Find the
DEVICE
CATEGORY
you wish to program (for
example
TV, CBL, DVR, DVD, SAT,
AMP, AUX 1, AUX 2
) and then find the
BRAND
of that device. Circle all the
codes under that brand. Example: For
a GE TV, locate the TV code section
then circle all of the GE TV codes.
2. Manually turn on the device you wish
to control.
3. Press and hold the
SETUP
button
until the red indicator light stays on
(approximately 2 seconds) and then
release the
SETUP
button.
4. Press and release the device button on
the remote (
TV, CBL, DVR, DVD, SAT,
AMP, AUX 1, AUX 2
). The red indicator
will blink once and then remain on.
5. Enter the first 4-digit code previously
found in the code list using the
number buttons on the remote. If the
code entered is a valid code, the red
indicator light will turn off. If the code
entered is not a valid code, the red
indicator light will flash and remain on
allowing you to re-enter the code.
Note: If no buttons are pressed for 35
seconds, the remote will exit the SETUP
mode and you will have to start over.
