6
W
ALL
M
OUNT
I
NSTALLATION
1. Pull up the handset hook and rotate it one-half
turn.
2. Remove the base plate from the back by
pressing down on the snap tabs located at the
top, and then lifting the base plate off.
3. Open the battery compartment cover. Thread
telephone line cord through the battery
compartment cover. Plug the telephone line
cord into the LINE jack. Close the battery
compartment cover.
4. Reverse the direction of the base plate and
replace it by putting the tabs into the slots on
the unit first, and then snapping the bottom
tabs into place.
5. Connect the other end of the telephone line
cord into the modular jack on the wall.
6. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into
place. (Wall plate not included.)
7. Set the PULSE/TONE switch (located on the
side of the unit) to TONE if you have touch-
tone service; set it to PULSE if you have rotary
service.
8. Plug the handset cord into the handset and
into the unit, and then hang up the handset.
1
2
3
4
5
7
PULSE/TONE switch
1
#
0
OPER
TONE
3
DEF
2
ABC
4
GHI
5
JKL
6
MNO
7
PQ
RS
8
TUV
9
WX
YZ
*
BUSY/REDIAL
REDIAL
ALARM
PAUSE
FLASH
MUTE
HOLD
SPEAKER
STORE
LOWER
AREA CODE PHONE NUMBER
SPEAKER PHONE
32 MEMORY
LOWER
SPEAKER
ABR LOW
8
NOTE: The easiest way to fit the telephone line
cord into the base plate is to leave it wrapped
up. Just unwrap enough cord to reach the
LINE jack and the modular wall jack.
6
