8
Operating Instructions
Safety Instructions
Consumer S
uppor
t
Tr
oubleshooting Tips
Enhancements
The light above the selected pad will be
ON
to indicate which
ENHANCEMENT
has been selected.
DELAY HOURS
You can delay the start of a wash cycle for up to 24 hours (depending on model).
Press the
DELAY HOURS
pad to choose the number of hours you want to delay the
start of the cycle; then press
START/RESET.
The machine will count down and start automatically at the correct time.
NOTE:
To cancel the
DELAY HOURS
selection before the cycle begins, repeatedly press
the
DELAY HOURS
pad until the display is blank.
ADDED HEAT
When selected, the cycle will run longer with heating element on to improve both wash
and dry performance.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
STEAM
For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
selected PRIOR to starting the cycle. The
STEAM
option adds 26 minutes to
the cycle time.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
HEATED DRY
When
HEATED DRY
is off, dishes will air dry.
Light Off
HEATED DRY
Turns the heater on for faster drying. This will extend the total cycle time between
Light On 8 and 38 minutes depending on the cycle selected.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
LOCK
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option
selected.
To unlock the dishwasher controls, press and hold the
HEATED DRY
pad for 3 seconds.
The light above the lock pad will turn off. To lock the dishwasher, press and hold the
HEATED DRY
pad for 3 seconds. The light above the
LOCK
pad will turn on.
RESET
To change a cycle after washing starts…
Touch the
START/RESET
pad to cancel the cycle. The
START/RESET
light will flash while
the water is pumped out if needed. This takes approximately 2 minutes.
Start
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
START/RESET
pad once to begin the cycle. Water fill begins immediately, and approximately 60 seconds
later the wash action begins.
When the dishwasher door is fully closed and latched, the control panel lights will display the last settings
you selected. If you don’t want to change any of the settings, simply touch the
START/RESET
pad to
begin the cycle.
If the door is closed, the indicator lights will turn off if the
START/RESET
pad is not selected within 5 minutes.
To activate the display, open and close the door or press any pad.
Clean
The
CLEAN
light will illuminate and a double beep will sound when a wash cycle is complete. The
CLEAN
light will turn off when the door is opened.
5
3
4
About the dishwasher control panel.
