GE 16X PTZ Camera
Installation Manual
10
Installation
Use the following installation guidelines:
•
A qualified service person, complying with all applicable codes, should perform all required hardware
installation.
•
Do not install the camera near the air outlet of an air conditioner.
•
Be sure to hook the lanyard (fall prevention wire) onto a bracket.
•
Seal cable parts tightly and do not expose them to rain or damp environments.
•
Use a 24 VAC/24 VDC UL listed class 2 power supply only.
•
When turned on, camera does a self-check, including panning, tilting, zooming, and focusing
operation.
Note:
Pendant-mount type configurations are IP66 environmentally rated. Flush-mount and surface-mount configurations are
not.
Removing the protective tape
Before using the camera, you must remove the protective tape. To remove the tape, do the following:
1. Use the supplied Allen wrench to loosen the screws and remove the dome cover (
Figure 10
).
Figure 10. Loosen dome screws
WARNING:
Be sure to switch the camera off before installation and connection.
