CyberScout User Manual
Operating the CyberScout
1038864A / December 2002
31
3 O
PERATING THE
C
YBER
S
COUT
You can operate your CyberScout in normal mode with a keypad or in
standalone mode with its DIP switch. See sections
3.1 Keypad Operation
and
3.2 Standalone Operation
.
CAUTION:
To ensure that units are operating properly, test the pan, tilt, and
lens functions once each week.
3.1 K
EYPAD
O
PERATION
You can program and operate autopan limits and presets from any
Kalatel keypad. Refer to your keypad’s manual for instructions.
Programming of ShadowTours and recalibrating are accomplished
differently per keypad. See Table 2.
Note:
The CyberScout has 64 presets (0 – 63).
Table 2. Keypad-specific CyberScout functions
Keypad
Function
KTD-400 KTD-404
KTD-405
CBR-
KB3/J
ShadowTour Programming
not
available, but
operation available.
Refer to your
keypad’s manual.
Requires a macro.
See section
3.1.1
Programming a
Macro
.
Request new
firmware for
keypad.
Not
available
Recalibration
Not available
Requires a macro.
See section
3.1.1
Programming a
Macro
.
Request new
firmware for
keypad.
Not
available
3.1.1 P
ROGRAMMING
C
YBER
S
COUT
M
ACROS INTO THE
KTD-404 K
EYPAD
Two macros must be programmed into the KTD-404 keypad for the
CyberScout. One is used to program a ShadowTour and the other is
used to recalibrate the CyberScout.
Note:
CyberScouts should not be recalibrated unless it is necessary. Refer to section
4 Troubleshooting
to learn when to recalibrate your CyberScout.
