4
ATP1000 Touchpad/Display Installation Instructions
3. Enter program mode by pressing
8
+ installer/dealer
CODE
+
0
+
0
and program the
panel using the panel
Installation Instructions.
4. When programming is completed, simply disconnect the programming touchpad.
To connect a programming touchpad to a Concord panel with software versions 1.0–1.6:
1. Disconnect AC and backup battery power.
2. Connect the cable plug onto the panel Programming Touchpad Header pins (see Figure 5).
3. Reconnect the AC and backup battery power. The touchpad briefly displays ***********,
SCANNING BUS DEVICES,
then shows a time and date display.
Note
If the touchpad does not respond as described in step 3, there may be a bus conflict. To correct this,
change the touchpad unit number as described in the section “Changing the Touchpad Unit Number.”
Removing the programming touchpad from Concord panels with software versions 1.0–1.6:
To prevent a trouble condition, you must delete the programming touchpad unit number from
Concord panel memory
before
disconnecting it.
1. After programming is completed, return to the
ACCESSORY MODULES
menu, then press
ƒ
.
The display should read
BUS DEVICES.
2. Press
ƒ
. The display shows the lowest unit number and its device name.
3. Press
A
or
B
until the display shows the programming touchpad unit number.
4. Press
D
to delete the device and its unit number from panel memory. The display shows:
UNIT - TYPE
14-NONE
5. Exit program mode and disconnect the programming cable from the panel header.
Testing
Note
Contact the central monitoring station before activating alarms, to avoid dispatching local police and fire
departments.
Test the touchpad by arming/disarming the system, activating the touchpad panics, bypassing
sensors, and by turning chime and lights on/off to verify correct operation. Refer to the panel
User’s Manual
for complete system operating instructions.
Adjusting
Display
Brightness and
Contrast
The touchpad display can be adjusted for easier viewing to help compensate for lighting condi-
tions in the touchpad location.
The brightness adjustment lightens or darkens the background. The contrast adjustment lightens
or darkens the text.
To adjust display brightness:
1. Enter user programming mode by pressing
9
+
user, partition, or system master
CODE
.
The display shows
SYSTEM MENU,
then
TIME AND DATE
(Concord panels with software versions 1.0–1.6 display
USER CODES.
)
2. Press
B
until the display shows
OPTIONS
, then press
ƒ
. The display shows
DOWNLOAD-
ING ON/OFF (current setting)
.
3. Press
B
twice and the display shows
TOUCHPAD BRIGHTNESS 2
(default setting).
4. Enter a setting from
0
(darkest background) to
3
(brightest background), then press
ƒ
.
5. The display flashes the entered selection, then stops after pressing
ƒ
and displays the new set-
ting and brightness level.
6. Exit user programming mode.
To adjust display contrast:
1.
Enter configuration mode by pressing the
D
and
6
buttons together for at least two seconds.
The display shows
DA nnn
.
2.
Press and release the
1
and
2
buttons together repeatedly, until the desired contrast level is
displayed.
3.
Press
‚
and the display briefly shows
DONE
, then shows the time and date.
