GE HEALTHCARE MAC 2000, Operator'S Manual

Page: 140 / 226

System Configuration
9. To edit a stage, do the following:
a. Select the stage to edit.
b. Press Edit .
The Edit Stage window opens.
c. Modify the stage parameters as appropriate.
Refer to the table preceding these instructions for a description of each
parameter.
d. When you are done, press OK .
The Edit Stage window closes.
10. To delete a stage, do the following:
a. Select the stage you want to delete.
b. Press Delete Stage .
The selected stage is deleted.
11. To remove custom Master’s Step stages, press Factory Defaults .
NOTE:
Reset treadmills and ergometers to factory defaults at the protocol level.
See step
15 .
12. Repeat steps 8 through 10 as necessary.
13. To rename the protocol, do the following:
a. Press Edit Name .
The Edit Name window opens.
NOTE:
This option is not available when editing a Master Step protocol.
b. Change the name as appropriate.
c. Press OK .
The protocol’s name is changed.
14. When you are done with the stages, press Save .
This saves your changes and returns you to the previous window.
15. To remove custom protocols, press Factory Defaults .
16. When the protocol is done, press Return .
The protocol is saved and you return to the Select Protocol window.
Communication Setup
The Communication Setup function allows you to define the following settings:
• Data Communication Settings and Shared Directory Settings
• FTP server settings
• Data Communication Locations
• Modem settings (if a modem option is activated)
140 MAC™ 2000 2053535-002K