GE Consumer & Industrial ZIC360NR, Technical Service Manual

Page: 8 / 51

– 8 –
Bolts
Track Bolt
Right Side of Machine Compartment
Bolt
Track Bolt
Screws
Left Side of Machine Compartment
Raise
Grille
Panel
to Stop
Position
Remove 2 Screws
Each Side to
CABINET
Cabinet
The outer case is made of galvanized steel. The
fresh food and freezer liners are painted metal with
a smooth finish. Individual fresh food and freezer
compartments provide separation and enhanced
individual control between the compartments. The
metal liner provides a thermal break between the
interior of the refrigerator and freezer
compartments and reduces the transfer of heat
from the room into the fresh food and freezer
compartments. The liner is not removable or
replaceable.
Machine Compartment
The machine compartment is located on the top of
the unit and has a movable chassis that can be
extended from the front of the unit to provide
access to the refrigeration system and
components.
Caution: Avoid kinking the refrigeration lines when
sliding the chassis out and back in.
To extend the chassis:
1. Raise the grille panel to stop position.
2. Remove the wire guard and door cover.
3. Remove the door switch.
4. Disconnect the door closure mechanism
spring from the pin and remove the pin by
turning it counterclockwise.
5. Remove the 2 screws securing the inverter.
6. Remove the door spring.
7. Remove the 2 front (7/16-in.) bolts from tray.
8. Loosen the 2 rear (7/16-in.) tray bolts.
9. Pull the chassis forward until it reaches the
stops in the tracks, working the refrigeration
tubing as you pull the chassis out.
Note. When sliding the chassis back into position,
be certain the lines and wiring have not fallen
behind the chassis.