– 34 –
Error
Condition
Solution
Fault
Water Level Sensor error :
“
1E
”
Water level sensor fails to send signal for longer
than 5 seconds.
Press “POWER” button.
No other buttons work.
Bad PCB or Pressure Sensor S/W.
Water Supply error :
“
FF
”
This occurs when the water supply is not finished
in 1 hour or there is no change in the water level 4
minutes after the water supply has started.
Press “POWER” button or
“START/PAUSE” button.
No other buttons work.
Bad PCB or Pressure Sensor S/W, or
Water-Valve
Drain Pump error :
“
dr
”
Water level does not decrease to reset point within
15 minutes from draining water from washer.
Press “POWER” button.
No other buttons work.
Bad PCB or Pump Moter.
Lid Open error :
“
L o
”
Lid is opened during wash cycle.
Close lid.
Bad PCB, Lid S/W, or Unbalance
S/W.
Unbalance S/W error :
“
Ub
”
Unbalanced load is sensed three times during a
wash cycle.
Open lid. Rebalance
laundry load and close lid.
Bad PCB or Unbalance S/W.
Water Leakage error :
“
LE
”
This occurs when it detects that the water level
has fallen below the reset water level for the third
time.
Press “POWER” button.
Bad PCB, Pressure sensor S/W,
Pump motor.
Overflow error :
“
OE
”
This occurs when overflow is sensed during
temporary stop, waiting action or spin action,
otherwise overflow is sensed three times during a
wash or rinse cycle.
Press “POWER” button.
Bad Drain hose, water valve,
Pressure sensor S/W.
Troubleshooting
NOTE:
It’s important to note error codes should only be used to help identify components which require
testing.
Never replace a part based solely on an error code.
The control can generate a false error if the
right conditions exist. Use the code only as a reference and always check the component before replacing.
Error Codes
