gdw 1217, Manual

Page: 5 / 8

Toyota Landcruiser BJ70 + HZJ74 + HZJ73
1985 - ....
Ref. 1217
Fitting instructions
1) Screw out the bolts on the outside of the chassis that attach the bumper, remove the tail lights out of the
bumper.
2) Place mounting pieces (-e) and (-f) against the outside of the chassis, fitting points (A) on the freed srew-
thread holes, insert the necessary bolts and washers, but do not tighten anything yet.
3) Place the tow bar with points (C) and (C’) on points (C) and (C’) of mounting pieces (-e) and (-f). Insert
the bolts and washers and tighten everything firmly. Drill the holes of points (B) through with ø10,5mm,
and insert mounting pieces (-g) in the chassis through the backside of the chassis. Insert the bolts through
the bottom of the chassis and tighten everything firmly.
4) Install the (*) and tighten firmly.
Composition
1 tow bar reference 1217
1 flange ball 50T90 (*)
6 bolts M10x35/1.25 (A)
2 bolts M10x30 (B)
2 bolts nuts (C’)
2 bolts M14x35 (C)
2 bolts nuts (*)
1 security shackle 50T (*)
8 safety washers 10mm (A-B)
4 safety washers 14mm (C-C’)
2 safety washers 16mm (*)
1 mounting piece (-e) (C-C)
1 mounting piece (-f) (C-C’)
2 mounting pieces (-g) (B)
All bolts and nuts : quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.