59
Step 3
Run cut test to check if the parameter settings need to be adjusted. To
start a cut test, move the bullet point to Cut test and press Enter key,
the settings will show as below. Use 4 arrow keys to set the position
that you want to start with, and press Enter to process the cut test. You
may press Pause
to abort the jog while test cutting.
Step 4
Adjust the settings value if needed. You may use Up or Down arrow key
to select the desired media settings and press Enter key to adjust the
value. If you want to abort the changes, press Pause key to go back to
upper page (Speed settings is taken as an example).
Step 5
Select the file from SD card and press Up or Down arrow key to select
the desired settings and press Enter key to adjust the value if needed.
If you want to abort the changes, press Pause key to go back to upper
page.
When the settings is done, press Cut key
on the control panel and
i-Craft
TM
will start to cut, then press Feed/Eject key
to unroll the media.
Step 6
The cutting job is done.
II
II
II
sample